Notizie del settore
The curvatubi is a new type of pipe bending tool with pipe bending function and lifting function. It has many advantages such as reasonable structure, safe use, convenient operation, reasonable price, fast loading and unloading, easy to carry, and one machine with multiple functions. It occupies a large share in the market of hydraulic pipe benders, and is mainly used in factories, warehouses, docks, buildings, and railways. Installation and repair of pipelines, automobiles, etc. In addition to the pipe bending function, it can also be used as a separate hydraulic jacking machine by removing the pipe bending parts.
Then, when purchasing the tube bending machine, pay attention to the following points when using it:
1. Before operation, please check whether the lubrication points of the machine are short of oil, whether the safety protection device is reliable, whether the movement mechanism is loose, wait for a confirmation and then start the operation.
2. Start the elbow oil pump and check whether the system pressure is maintained within the specified range. If it is high, it will damage the hydraulic components and waste power. If it is too low, it will affect the work.
3. Adjust the required position and angle of the parts, and position the machine to the required length.
4. Adjust the vertical lifting rail to make the guide mold pressing cylinder move forward to clamp the iron pipe tightly.
5. The clamping cylinder of the adjusting clamp can clamp the iron pipe.
6. Put the workpiece into the bending mold for normal operation, and the front end is in contact with the positioning, step on the foot switch to complete.
7. After the work is over, cut off the power supply and do a good job of cleaning and lubricating.
8. In case of emergency when operating the tube bending machine, you should press the emergency stop button, then turn the rotary switch to the manual position, and reset it manually. If there is a failure, please report for repair in time.
Then, when purchasing the tube bending machine, pay attention to the following points when using it:
1. Before operation, please check whether the lubrication points of the machine are short of oil, whether the safety protection device is reliable, whether the movement mechanism is loose, wait for a confirmation and then start the operation.
2. Start the elbow oil pump and check whether the system pressure is maintained within the specified range. If it is high, it will damage the hydraulic components and waste power. If it is too low, it will affect the work.
3. Adjust the required position and angle of the parts, and position the machine to the required length.
4. Adjust the vertical lifting rail to make the guide mold pressing cylinder move forward to clamp the iron pipe tightly.
5. The clamping cylinder of the adjusting clamp can clamp the iron pipe.
6. Put the workpiece into the bending mold for normal operation, and the front end is in contact with the positioning, step on the foot switch to complete.
7. After the work is over, cut off the power supply and do a good job of cleaning and lubricating.
8. In case of emergency when operating the tube bending machine, you should press the emergency stop button, then turn the rotary switch to the manual position, and reset it manually. If there is a failure, please report for repair in time.